Reliability Evaluation of a Radial Feeder Configurations by Replacing the Distribution Transformer with the Solid-State Transformer

Main Article Content

G. Kiran Kumar
Dr. E. Vidya Sagar

Abstract

The radial feeder is the most typical power distribution system configuration for distributing power to the consumer through the distribution transformer. Distribution transformers are a key component of power distribution systems, they enable voltage transformation, improve safety, reduce energy losses, enhance network reliability, and facilitate the efficient distribution of electricity to consumers. Due to the lack of their role in balancing loads and integrating renewable energy sources, they must be replaced with an alternate solution for modernizing and optimizing distribution grids. A solid-state transformer (SST) is a power electronic device that, in many ways, may replace a typical distribution transformer (DTR). It also improves controllability and provides a direct current link, making it simple to integrate distributed energy sources on either sides of medium and low voltage. However, reliability is the most important parameter in restricting its applications. Modularity is one of the ways to improve reliability and availability by directly re-routing the power within the modular system. This work investigates the failure rate of a modular SST by determining the number of module units required in SST design based on the available IGBT ratings. Further, the reliability of a radial feeder is evaluated by considering the configuration of a) without AS and with DTRs, b) Without AS and replacement of DTRs with SST, c) With AS and DTRs, and d) With AS and replacement of DTRs with SST.

Downloads

Download data is not yet available.

Article Details

How to Cite
[1]
G. Kiran Kumar and Dr. E. Vidya Sagar , Trans., “Reliability Evaluation of a Radial Feeder Configurations by Replacing the Distribution Transformer with the Solid-State Transformer”, IJRTE, vol. 12, no. 4, pp. 1–5, Dec. 2023, doi: 10.35940/.
Section
Articles
Author Biography

Dr. E. Vidya Sagar, Department of Electrical Engineering, University College of Engineering, Osmania University, Hyderabad, (Telangana), India.

 

 

How to Cite

[1]
G. Kiran Kumar and Dr. E. Vidya Sagar , Trans., “Reliability Evaluation of a Radial Feeder Configurations by Replacing the Distribution Transformer with the Solid-State Transformer”, IJRTE, vol. 12, no. 4, pp. 1–5, Dec. 2023, doi: 10.35940/.
Share |

References

Xu She, A. Q. Huang, and R. Burgos, “Review of Solid-State Transformer Technologies and Their Application in Power Distribution Systems,” IEEE J. Emerg. Sel. Top. Power Electron., vol. 1, no. 3, pp. 186–198, Sep. 2013, doi: 10.1109/JESTPE.2013.2277917. https://doi.org/10.1109/JESTPE.2013.2277917

I. Syed, V. Khadkikar, and H. H. Zeineldin, “Loss Reduction in Radial Distribution Networks Using a Solid-State Transformer,” IEEE Trans. Ind. Appl., vol. 54, no. 5, pp. 5474–5482, Sep. 2018, doi: 10.1109/TIA.2018.2840533. https://doi.org/10.1109/TIA.2018.2840533

X. Wang, J. Liu, T. Xu, and X. Wang, “Comparisons of different three-stage three-phase cascaded modular topologies for Power Electronic Transformer,” in 2012 IEEE Energy Conversion Congress and Exposition (ECCE), IEEE, Sep. 2012, pp. 1420–1425. doi: 10.1109/ECCE.2012.6342648. https://doi.org/10.1109/ECCE.2012.6342648

J. S. Lai, A. Maitra, A. Mansoor, and F. Goodman, “Multilevel intelligent universal transformer for medium voltage applications,” in Conference Record - IAS Annual Meeting (IEEE Industry Applications Society), IEEE, 2005, pp. 1893–1899. doi: 10.1109/IAS.2005.1518705. https://doi.org/10.1109/IAS.2005.1518705

A. Hyde, “Advanced power converters for universal and flexible power management in future electricity networks: The UNIFLEX-PM project,” 2009. doi: 10.1080/09398368.2009.11463731. https://doi.org/10.1080/09398368.2009.11463731

L. Ferreira Costa, G. De Carne, G. Buticchi, and M. Liserre, “The Smart Transformer: A solid-state transformer tailored to provide ancillary services to the distribution grid,” IEEE Power Electron. Mag., vol. 4, no. 2, pp. 56–67, Jun. 2017, doi: 10.1109/MPEL.2017.2692381. https://doi.org/10.1109/MPEL.2017.2692381

M. Liserre, G. Buticchi, M. Andresen, G. De Carne, L. F. Costa, and Z.-X. Zou, “The Smart Transformer: Impact on the Electric Grid and Technology Challenges,” IEEE Ind. Electron. Mag., vol. 10, no. 2, pp. 46–58, Jun. 2016, doi: 10.1109/MIE.2016.2551418. https://doi.org/10.1109/MIE.2016.2551418

J. Li, Yang; Yan, Zhang;Rui ,Cao; Liu, Xue; Lv, Chunlin ; Liu, “Redundancy Design of Modular DC Solid-State Transformer Based on Reliability and Efficiency Evaluation,” CPSS Trans. Power Electron. Appl., vol. 6, no. 2, pp. 115–126, Jun. 2021, doi: 10.24295/cpsstpea.2021.00010. https://doi.org/10.24295/CPSSTPEA.2021.00010

A. Shri, “A solid-state transformer for interconnection between the medium and the low voltage grid,” Delft University of Technology, 2013. [Online]. Available: http://repository.tudelft.nl/view/ir/uuid:3bb366d5-6f87-4636-a4a3-0245269125f5/

K. Wang, Q. Lei, and C. Liu, “Methodology of reliability and power density analysis of SST topologies,” in 2017 IEEE Applied Power Electronics Conference and Exposition (APEC), IEEE, Mar. 2017, pp. 1851–1856. doi: 10.1109/APEC.2017.7930950. https://doi.org/10.1109/APEC.2017.7930950

R. Billinton and R. N. Allan, “Reliability Evaluation of Power Systems,” Reliab. Eval. Power Syst., 1996, doi: 10.1007/978-1-4899-1860-4. https://doi.org/10.1007/978-1-4899-1860-4

R. E. Brown, “Electric Power Distribution Reliability,” Electr. Power Distrib. Reliab., Mar. 2002, doi: 10.1201/9780824744281. https://doi.org/10.1201/9780824744281

R. Billinton and P. Wang, “Distribution system reliability cost/worth analysis using analytical and sequential simulation techniques,” IEEE Trans. Power Syst., vol. 13, no. 4, pp. 1245–1250, 1998, doi: 10.1109/59.736248. https://doi.org/10.1109/59.736248

R. N. Allan, R. Billinton, I. Sjarief, L. Goel, and K. S. So, “A Reliability Test System For Educational Purposes - Basic Distribution System Data and Results,” IEEE Trans. Power Syst., vol. 6, no. 2, pp. 813–820, 1991, doi: 10.1109/59.76730. https://doi.org/10.1109/59.76730

M. C. Magro and S. Savio, “Reliability and availability performances of a universal and flexible power management system,” IEEE Int. Symp. Ind. Electron., pp. 2461–2468, 2010, doi: 10.1109/ISIE.2010.5637723. https://doi.org/10.1109/ISIE.2010.5637723

Kareem*, M. A., Ganesh, N., & RAo, P. R. (2020). Power Quality Improvement using DSTATCOM for Power System. In International Journal of Recent Technology and Engineering (IJRTE) (Vol. 8, Issue 5, pp. 385–388). https://doi.org/10.35940/ijrte.e4969.018520 https://doi.org/10.35940/ijrte.E4969.018520

Irfan*, M. M., Chandrashekhar, Dr. P., & Sushama, Dr. M. (2019). Power Management Policies in Distributed Generation and Potential Opportunities for Future Research. In International Journal of Innovative Technology and Exploring Engineering (Vol. 9, Issue 2, pp. 143–148). https://doi.org/10.35940/ijitee.a5260.129219

Bahadur, S. A., Murugan, A., Siva, V., & Shameem, A. (2019). Nanocrystalline Cuco2se4 Thin Film Counter Electrode for Dye-Sensitized Solar Cells. In International Journal of Engineering and Advanced Technology (Vol. 9, Issue 1s4, pp. 370–373). https://doi.org/10.35940/ijeat.a1184.1291s419

Brahamne, P., Chawla, Assoc. Prof. M. P. S., & Verma, Dr. H. K. (2023). Optimal Sizing of Hybrid Renewable Energy System using Manta Ray Foraging Technique. In International Journal of Emerging Science and Engineering (Vol. 11, Issue 3, pp. 8–16). https://doi.org/10.35940/ijese.c2545.0211323

Gupta, S. K. (2022). Smart Grid System in India. In Indian Journal of Energy and Energy Resources (Vol. 1, Issue 4, pp. 5–6). https://doi.org/10.54105/ijeer.c1018.081422

Most read articles by the same author(s)

1 2 3 4 5 6 7 > >>