Exploring the Performance of Dry Bamboo Leaves Powder from Bambusa Heterostachya as Additive in Water-Based Mud
Article Sidebar
Main Article Content
Abstract
In the evolving landscape of petroleum drilling, the quest for eco-friendly alternatives to traditional mud additives is paramount. This study explored the performance of Dry Bamboo Leaves Powder (DBLP) from Bambusa heterostachya as an additive in water-based mud. Dry Bamboo Leaves were obtained, crushed, and then sieved to 106-micron size. Mud properties, including mud weight, plastic viscosity, yield point, gel strength, mud cake thickness and filtrate volume were examined under fresh conditions by integrating different concentrations of DBLP (3.5 g, 7.0 g, 10.5 g, and 14 g). The laboratory experiments adhered to the standards set by the American Petroleum Institute (API). The introduction of DBLP concentrations resulted in a reduction in the alkalinity and mud weight of the drilling mud. Additionally, the drilling mud's yield point and plastic viscosity were altered at different DBLP concentrations. The inclusion of DBLP enhanced the gel strength and decreased filtrate volume while maintaining the same mud cake thickness.
Downloads
Article Details
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
How to Cite
References
Kwaw JA, Broni-Bediako E. Effect of salinity (KCl) on rheological properties and rate of penetration of treated bentonite and Ca2+ based polymer drilling mud. International. Journal of Research and Scientific Innovation (IJRSI). 2022;9(10):15-21.
Medhi S, Chowdhury S, Gupta DK, Mazumdar A. An investigation on the effects of silica and copper oxide nanoparticles on the rheological and fluid loss properties of drilling fluids. J. Pet. Explor. Prod. Technol. 2020; 10:91–101. https://doi.org/10.1007/s13202-019-0721-y.
Medved I, Gaurina-Medimurec N, Novak MK, Mijic P. Waste mandarin peel as an eco-friendly water-based drilling Fluid Additive. Energies. 2022;15, 2591:1-18. https://doi.org/10.3390/en15072591
Rafieefar A, Sharif F, Hashemi A, Bazargan AM. Rheological behaviour and filtration of water-based drilling fluids containing graphene oxide: Experimental measurement, mechanistic understanding, and modeling. ACS Omega. 2021; 6(44):29905-29920. https://doi.org/10.1021/acsomega.1c04398
Nguyen T. Drilling fluids components. Unpublished BSc lecture, Science Material Engineering Research University, New Mexico. 2012:27.
Amanullah M. Screening and evaluation of some environment-friendly mud additives to use in water-based drilling muds. In Proceedings of the SPE E&P Environmental and Safety Conference, Galveston, TX, USA, 5-7 March 2007. https://doi.org/10.2118/98054-MS
Al-Hameedi ATT, Alkinani HH, Dunn-Norman S, Alashwak NA, Alshammari AF, Alkhamis MM, Alsaba MT. Environmental friendly drilling fluid additives: can food waste products be used as thinners and fluid loss control agents for drilling fluid? April 19. Society of Petroleum Engineers. 2019. https://doi.org/10.2118/195410-MS
Parvizi Ghaleh S, Khodapanah E, Tabatabaei-Nezhad SA. Experimental evaluation of thiamine as a new clay swelling inhibitor. Pet. Sci. 2020; 17:1616–1633. https://doi.org/10.1007/s12182-020-00466-6.
Borah B, Das, BM. A review on applications of bio-products employed in drilling fluids to minimize environmental footprint. Environmental Challenges 6. 2022:1-18. https://doi.org/10.1016/j.envc.2021.100411
Ikram R, Mohamed Jan B, Sidek A, Kenanakis G. Utilization of eco-friendly waste generated nanomaterials in water-based drilling fluids; state of the art review. Materials. 2021; 14, 4171:1-28. https://doi.org/10.3390/ma14154171.
Al-Hameedi ATT, Alkinani HH, Dunn-Norman S, Al-Alwani MA, Alshammari AF, Alkhamis MM, Mutar RA, Al-Bazzaz WH. Experimental investigation of environmentally friendly drilling fluid additives (mandarin peels powder) to substitute the conventional chemicals used in water-based drilling fluid. Journal of Petroleum Exploration and Production Technology. 2020; 10:407–417. https://doi.org/10.1007/s13202-019-0725-7.
Al Hameedi ATT, Alkinani HH, Alkhamis MM, Dunn Norman S. Utilizing a new eco-friendly drilling mud additive generated from wastes to minimize the use of the conventional chemical additives. Journal of Petroleum Exploration and Production Technology. 2020; 10:3467–3481. https://doi.org/10.1007/s13202-020-00974-6.
Omotioma M, Ejikeme PCN, Mbah GO. Comparative analysis of the effects of cashew and mango extracts on the rheological properties of water-based mud. J Eng Res Appl. 2014; 4:56–61.
Ismail AR, Mohd NM, Basir NF, Oseh JO, Ismail I, Blkoor SO. Improvement of rheological and filtration characteristics of water-based drilling fluids using naturally derived henna leaf and hibiscus leaf extracts. Journal of Petroleum Exploration and Production Technology. 2020; 10:3541–3556. https://doi.org/10.1007/s13202-020-01007-y.
Nyeche W, Nmegbu J, Ifeoma P. Drilling mud formulation using potato starch (Ipomoea batatas). Journal of Engineering Research and Applications 5, 2015: 48–54.
Adebowale A, Raji J. Local content supplements as an alternative to imported corrosion control additives for drilling mud treatment (a case study of the use of burnt plantain and banana peels). In: Proceedings of the International Academic Conference for sub-Sahara African Transformation and Development. 2015.
Okon AN, Udoh FD, Bassey PG. Evaluation of rice husk as fluid loss control additive in water-based drilling mud. Society of Petroleum Engineers.2014. https://doi.org/10.2118/172379-ms.
Anglaaere L, Djaney DG, Aninagyei OD, Kudjo GD, Okyere-Agyapong E, Kwaku M, Nti, AE. Manual for Bamboo Agroforestry Systems in Ghana. INBAR Working Paper. 2020:1-40.
Asha P, Salman A, Kumar RA. Experimental study on concrete with bamboo leaf ash. International Journal of Engineering and Advanced Technology. 2014; 3(6):46-51.
Betaubun P, Limantara LM. The Usage of Bamboo as the Concrete Carcass Due to the Pressure and Diffraction Strength. In International Journal of Innovative Technology and Exploring Engineering. 2019; 8(11):875-882. https://doi.org/10.35940/ijitee.k1537.0981119
Inamdar SJ, Patil U, Lodam H. Thermal Energy Storage System using Bamboo in Combination with PCM. International Journal of Engineering and Advanced Technology. 2019; 8(6): 865-869. https://doi.org/10.35940/ijeat.f1163.0886s19
Gatie AA, Abegaze KA, Bitew WT. Investigation of traditional bamboo house construction practice and the need for bamboo construction technology in Awi Zone. International Journal of Advanced Engineering and Nano Technology. 2024;11(6): 1-6. https://doi.org/10.35940/ijaent.b8096.11060624
Ogbeide PO, Igbinere SA. The effect of additives on rheological properties of drilling fluid in highly deviated wells. Futo Journal Series. 2016; 2(2): 68-82.
Yunita P, Irawan S, Kania D. Optimization of water-based drilling fluid using non-ionic and anionic surfactant additives. Procedia Engineering. 2016; 148: 1184-1190. https://doi.org/10.1016/j.proeng.2016.06.628.
Abduo MI, Dahab AS, Abuseda H, AbdulAziz AM, Elhossieny MS et al. Comparative study of using water-based mud containing multiwall carbon nanotubes versus oil-based mud in HPHT fields. Egyptian Journal of Petroleum. 2016; 25(4): 459-464. https://doi.org/10.1016/j.ejpe.2015.10.008.
Broni-Bediako E, Amorin R. Experimental study on the effects of cement contamination in a water-based mud. Advances in Geo-Energy Research. 2019; 3(3): 314-319. https://doi.org/10.26804/ager.2019.03.09
Das B, Chatterjee R. Wellbore stability analysis and prediction of minimum mud weight for few wells in Krishna-Godavari Basin, India. Int. J. Rock Mech. Min. Sci. 2017; 93:30–37. https://doi.org/10.1016/j.ijrmms.2016.12.018
Ebikapaye J. Effects of temperature on the density of water-based drilling mud. J. Appl. Sci. Environ. Manag. 2018; 22: 406-408. https://doi.org/10.4314/jasem.v22i3.20
Al-Hameedi ATT, Alkinani HH. Dunn-Norman S, Al-Alwani MA, Al-Bazzaz WH, Alshammari AF, Albazzas HW, Mutar RA. Experimental investigation of bio-enhancer drilling fluid additive: Can palm tree leaves be utilized as a supportive eco-friendly additive in water-based drilling fluid system? Journal of Petroleum Exploration and Production Technology. 2020 10:595–603. https://doi.org/10.1007/s13202-019-00766-7.
Al-Hameedi ATT, Alkinani, HH, Dunn-Norman, S, Al-Alwani, MA. Alshammari, AF, Albazzaz HW, Alkhamis MM, Alashwak NF, Mutar RA. Insights into the application of new eco-friendly drilling fluid additive to improve the fluid properties in water-based drilling fluid systems. J. Pet. Sci. Eng. 2019, 183, 106424. https://doi.org/10.1016/j.petrol.2019.106424
Delikesheva D, Syzdykov AK, Ismailova J, Kabdushev A, Bukayeva G. Measurement of the plastic viscosity and yield point of drilling fluids. Int. J. Eng. Res. Technol. 2020; 13:58–65. https://doi.org/10.37624/IJERT/13.1.2020.58-65
Annis MR, Smith MV. Drilling fluid technology. Exxon Company, U.S.A. 1996.
Broni-Bediako E, Ocran D, Johnson RT, Larweh SL. Characterisation of iron ore from Opon Mansi in Ghana and its potential as a weighting agent in a water-based mud. Ghana Journal of Technology. 2023;7(1):62 – 72.
Gaurina-Medjimurec N, Steiner I, Simon K, Matanovic D. Avoidance of formation damage by application of proper drill-in fluid (A Case Study of a Mature Field). In Proceedings of the SPE European Petroleum Conference, Paris, France, 24-25 October 2000. https://doi.org/10.2523/65185-MS
Gaurina-Medjimurec N. Laboratory Evaluation of Calcium Carbonate Particle Size Selection for Drill-in fluids. Rud. Geološko-Naft. Zb. 2002; 14:47–53. https://doi.org/10.2523/65185-MS.
Baker Hughes. Drilling Engineering Workbook. Distributed Learning Course. Houston, USA.1995.
Rasool MH, Ahmad M, Siddiqui NA, Junejo AZ. Eco-friendly drilling fluid: Calcium Chloride-Based Natural Deep Eutectic Solvent (NADES) as an all-rounder additive. Energies. 2023; 16, 5533. https://doi.org/10.3390/en16145533.
Betaubun, P., & Limantara, L. M. (2019). The Usage of Bamboo as the Concrete Carcass Due to the Pressure and Diffraction Strength. In International Journal of Innovative Technology and Exploring Engineering (Vol. 8, Issue 11, pp. 875–882). https://doi.org/10.35940/ijitee.k1537.0981119
Inamdar, S. J., Patil, U., & Lodam, H. (2019). Thermal Energy Storage System using Bamboo in Combination with PCM. In International Journal of Engineering and Advanced Technology (Vol. 8, Issue 6s, pp. 865–869). https://doi.org/10.35940/ijeat.f1163.0886s19
Gatie, A. A., Abegaze, K. A., & Bitew, Dr. W. T. B. (2024). Investigation of Traditional Bamboo House Construction Practice and the Need for Bamboo Construction Technology in Awi Zone. In International Journal of Advanced Engineering and Nano Technology (Vol. 11, Issue 6, pp. 1–6). https://doi.org/10.35940/ijaent.b8096.11060624